What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Last Updated: 02.07.2025 23:40

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

One

A fuse is a non-resetable over current circuit protector.

Study tightens King plot-based constraints on hypothetical fifth force - Phys.org

It also is a device that limits the change in current flow.

nine

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

Can you name an example of bad parenting?

a photo is worth a thousand words.

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

In schematic diagrams this is the symbol for a fuse:

Pacific sediment cores unlock millions of years of climate history - Earth.com

An AC voltage/ current source, and an ac inductive load.

Barnstars:

He then describes Rainy Season and Lightning.

Why can't I lose weight?

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

This is the picture of an electronic coil of wire wound around a core of magnetic material.

what exactly is a ‘surge’ protector?

NFL Declines Comment on Viral Video of Patriots' Stefon Diggs Partying on Boat - Bleacher Report

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

Have you ever been physically attacked by a demon?

At one ohm, the resistor has a maximum of 1 watt power.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

What does a fuse do?

Walking more may lower your risk for chronic low back pain by 23%, study suggests - KSL.com

the problem then depends on "how fast does the fuse operate?".

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

Can the fuse protect the electronic devices from lightning instead of a surge protector.

Safeway workers begin striking in 4 Colorado cities - 9News

A circuit breaker is similar, but is resettable.

2024–10–16 [ OO OLAOYE OYEBODE ]

These devices are installed between the “hot” and “neutral” and protective ground.

Justin Bieber posts cryptic message about 'transactional relationships' after fans begged him to 'get help' - Page Six

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

So, the voltage could go up to 500 volts, and the fuse will not open up.

What is the difference between heaven and heavens?

What is lightning?

These are simplified answers to the original question, and does not change anything I wrote above.

I post the exact comment here.

France blown away! Records sent tumbling as Les Bleus concede five goals for the first time in 56 YEARS against incredible Spain - Goal.com

The MOV will conduct when the voltage exceeds 50% of line voltage.

He then describes the function of a fuse.

The bolt then partially travels down the line to your home.

T.J. Oshie, the Caps’ beloved ‘warrior,’ announces his NHL retirement - The Washington Post

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

Here is a simplified AC power diagram.

but I think this circuit , shows a few more pieces.

Do you think that drug addiction is a symptom of larger societal ills? What is it about our culture that leaves so many feeling like they're inadequate, trying any ill to find a cure?

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

The third is lightning and “how it gets conducted into a home.”

Report: Leafs discussed 3-way deal at deadline to send Marner to Vegas - theScore.com

But… the neutral is now “floating” because of the 1 ohm resistance.

[image of Common-mode choke]

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

Corbin Carroll Diagnosed With Wrist Fracture - MLB Trade Rumors

There are two important concepts here.

2024–10–14 [Omar Gharbi Omar Gharbi ]

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

so, what happens?

One is “what exactly is in a ‘surge protector’ ? ”

Upvotes:

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

But it can get overloaded, and no longer works.

(Dc diagram shown, AC is similar).

Edit 2024–10.

2024–10–10[John johnson John Johnson ]

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

This one hit behind the barn.

This is where the MOV conducts again, and dissipated the energy.

but this device (an Inductor) … impedes the rapid changes in the current.

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

It seems Mohan does not understand the difference between a comment and an Answer.

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

This device then solves the entire problem.

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

eight

This is where this question deviates from being a 'generic' question, and becomes more specific.

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

The other is “what does a “fuse” do?”

He then asserts :

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

[old diagram got deleted by accident]

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

At least they know the answer if they wanted it.

There are three different concepts here that are getting confused.

This is 'the assistant's answer'

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

For this case there are devices called Metal oxide varistors (MOV).

First Sentence:

Because the load is inductive, the current lags the voltage.(by a bit).

Now when you have a certain ac resistance, then a current flows in a loop.